After Use; Drip-Stop Function; Automatic Switch-Off; Cleaning - Silvercrest SDBE 2600 A1 Operating Instructions Manual

After use

GB
■ Remove the power plug from the mains power
socket.
■ Empty the water tank and clean the sole of the
iron 0.
Place the cooled-down steam iron on the base 9.
■

Drip-Stop function

With conventional steam irons, water can drip from
the sole of the iron 0 at low temperatures.
This iron, however, possesses a new feature: the
DRIP-STOP function. At low temperatures the iron
automatically switches off the steam-blast function.
Then set a suitable temperature with the tempera-
ture control 6. As soon as this is reached, steam
production is resumed.
Automatic switch-off
This steam iron is fi tted with an automatic switch-off
system. This stops the iron from heating up.
If the iron is resting on its sole 0 and is not moved
for about 30 seconds, there will be a warning beep
and the control lamp for the automatic switch-off 7
fl ashes. The iron will stop heating up. To deactivate
the automatic switch-off , lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off 7 goes out and the iron will
heat up again.
8
If the iron is resting on its base 9 and is not moved
for about 8 seconds, there will be a warning beep
and the control lamp for the automatic switch-off 7
fl ashes. The iron will stop heating up. To deactivate
the automatic switch-off , lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off 7 goes out and the iron will
heat up again.
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power! This is merely intended to reduce the fi re
hazard if you forget to switch of the iron!

Cleaning

Self-cleaning function

■ Fill the water tank to the "MAX" marking.
■ Insert the plug into the mains power socket.
Move the temperature control 6 to the "MAX"
■
position.
Set the steam control 3 to maximum steam
■
power.
■ Allow the steam iron to heat up until the heat
control lamp 7 goes out and then lights up
again.
■ Hold the steam iron horizontally over a suitable
container.
Press and hold down the self-clean button q.
■
Move the steam iron back and forth a little.
Steam and boiling water will fl ow from the
steam exit holes in the sole of the iron 0. Any
impurities that may be present are fl ushed out.
Release the self-clean button q as soon as all
■
of the water has fl own out of the water tank.
SDBE 2600 A1