Programming (Cont.); Deleting; How To Delete A Switch Or Remote Button From Memory.; How To Delete All Programmed Switches And Remotes From Memory. - Wise Controls WisePack Simple Instructions

3. How to program a 2 button on/off function to the WisePack Switching.
Programming the WisePack Switching this way will result in 1 button being solely on, and
a) Make sure that the mains 240V supply into the WisePack Switching is ON.
b) Press the 'MEM1' button twice and hold. (The buzzer will sound continuously).
c) With 'MEM1' held down, press one of the buttons on the wall or remote switch (must be a 2 button switch, minimum)
d) The buzzer will sound intermittently to confirm the programming is successful.
e) You will now be able to turn ON only with button 1 and turn OFF only with button 2.
f) Repeat this procedure for channel 2, if function is required.
g) Repeat this procedure for all Switches and Remotes that you want programmed to the WisePack Switching.
4.

How to delete a switch or remote button from memory.

a) Press and hold the 'DEL' button, then press the switch button that controls that channel.
b) The switch button will no longer control that channel.
5.

How to delete all programmed switches and remotes from memory.

a) Press the 'DEL' button and hold for over 1 second. (The buzzer will sound intermittently).
b) Release the 'DEL' button and hold again within 0.5 seconds.
c) Hold until the Buzzer sounds continuously (approximately 10 seconds)
d) All programmed switches and remotes will now be deleted from memory.
wise pack switch receiver

PROGRAMMING (CONT.)

the second being solely off.

DELETING

wise controls