Specifications; Troubleshooting - Honeywell DC515 Series Operation Manual

Specifications

Operating Temperature
Honeywell Home ActivLink™
Range (open field)
Sound Level (typical)
Battery Type
Battery Life (5 activations/day)
Rain proof

Troubleshooting

If
The doorbell does not work
Two 'beep' sounds are
heard after the normal tune
Range is reduced
*Under these scenarios the push button is considered the "transmitter". Other
examples of transmitters are the wireless motion (PIR) sensor or wireless door
window sensor.
Doorbell
-5ºC to 40ºC
868 MHz
150 m
84 dB
3 x LR6(AA) 1.5V - battery
models only
Up to 2 years - battery models
only
N/A
1. Press the Mute button until all of the Mute lights are off.
2. Ensure the correct batteries are installed in both the push and doorbell
with the correct polarity.
3. The doorbell might be out of range; try the doorbell in a different
location.
4. Reconnect the doorbell. See "Connect a Push Button" on page 7.
5. Check all the batteries and replace if needed.
6. Check if the confidence LED on the transmitters is working when
activated.
7. Check if the doorbell is muted.
8. Check that the transmitter is linked with the chime.*
Replace push button battery with a new CR2032.
1. Metal structures including uPVC door frames can reduce the range.
Don't mount the doorbell or push button on or near metal structures.
2. Move the doorbell closer to the push button.
3. Weak batteries will reduce range. In cold conditions (below 5ºC), the
batteries may need to be replaced more often.
9
Push Button
-20ºC to 50ºC
868 MHz
150 m
-
CR2032
Up to 2 years
IP55
Then