Connection To The Mains Supply - Kalorik TKG CV 1003 T User Manual

Fax +32 2 359 95 50

Do not insert any objects through the grille or into the interior of the appliance.

(*) Competent qualified service: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this service.

CONNECTION TO THE MAINS SUPPLY

Caution: We cannot be held responsible for any damage due to the wrong use or the non-
observance of this instruction manual.
The convection heater should only be connected to an earthed socket installed in
accordance with the regulations. Make sure that the supply voltage corresponds with the
voltage marked on the rating label.
This product complies with the CE-directives.
BEFORE THE FIRST USE
Before using the convection heater for the first time, you must either attach the feet to the
base of the unit or mount the appliance on the wall.
Floor-standing (see page 4)
Attach each foot underneath the appliance by tightening two screws provided in the holes
foreseen to this effect as indicated on page 4. Make sure to install the appliance at a minimum
distance of 50 cm to other objects or walls. Do not use the appliance on the floor if the feet
have not been assembled correctly.
Wall-mounting (see pictures on page 4)
Caution: - there should be a distance of at least 40 cm between the lower part of the
appliance and the floor.
- the feet must be removed before mounting the appliance on the wall.
1. Measure the distance between the two slots situated at the back of the appliance (see
picture A).
2. Drill two holes at the same distance in the wall and insert a plug in each hole you just
drilled. Place the brackets facing the holes as indicated on picture B and attach them in
this position with the screws supplied.
3. Before attaching the appliance on the brackets, attach the two other brackets
underneath the appliance as indicated on picture C.
4. Attach the appliance on the wall. To do so, hold it in such a way that the slots are facing
the brackets, insert the appliance halfway onto the brackets until the appliance can go
down into the grooves of the brackets.
5. As soon as the appliance is positioned correctly, take a pencil and mark a dot in the hole
of each bracket situated underneath the appliance.
6. Then take off the appliance by proceeding the other way around compared to point 4
above.
7. Drill a hole in the wall on each dot you just marked and insert a plug in each hole.
8. Attach the appliance back on the wall as indicated in point 4, insert screws through the
brackets underneath the appliance and tighten without forcing.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/44
TKG CV 1003 T - 140521