Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Advertisement
Table of Contents
Related Manuals for Jung FRWM-AR
Summary of Contents for Jung FRWM-AR
-
Page 1: Wartung
FRWM-AR ALBRECHT JUNG GMBH & CO. KG Volmestraße 1 58579 Schalksmühle www.jung.de Betriebsanleitung Alarmrelais mit potentialfreiem Eingang Operating manual Alarm relay with fl oating input... -
Page 2: Table Of Contents
10 Verpackung, Transport und Lagerung 18 11 Air humidity, Ambient temperature 11 Luftfeuchtigkeit, 12 Maintenance Umgebungstemperatur 13 Waste disposal 12 Wartung 14 Accessories, spare parts & service 13 Entsorgung 15 Technical Specifications 14 Zubehör, Ersatzteile & Service 15 Technische Daten Betriebsanleitung: FRWM-AR Alarmrelais... -
Page 3: Notes On The Operating Manual
It is absolutely necessary that the operating manual is read and understood. For better readability, the FRWM-AR alarm relay is hereinafter referred to as "FRWM-AR" or "device". 1.1 Scope of the operating manual This operating manual only applies for the pro- duct designation FRWM-AR alarm relay. - Page 4 1.7 Disclaimer action Except for the legal warranty, ALBRECHT 5 Result of an action JUNG GMBH & CO. KG assumes no additi- Symbol for a list • onal explicit or implicit liability under the ap- plicable statutory provisions. This shall also...
- Page 5 1.8 Limitation of liability Your rights are limited to the repair or replace- ment of this device as shipped. ALBRECHT JUNG GMBH & CO. KG shall accept no liability for any special, incidental or conse- quential damages, including, but not limited...
-
Page 6: Safety Instructions
Type and source of the danger! If a battery replacement is required, please Explanation about the type and source. send the device to ALBRECHT JUNG GMBH f Measures to avert the danger. & CO. KG. Our specia- lists will then undertake... - Page 7 • Moisture • Cold Along with the operating manual and quick- • Contamination of any kind start guide for the FRWM-AR, the operating manuals for the corresponding radio smoke Immersion in water alarm devices also apply: Immersion in water can cause damage to f Observe the operating manual for the the device.
- Page 8 Do not expose the batteries to temperatures above 65 °C. With intended use of the device and an intact battery cell, the electrode and electrolyte mate- rial is not released into the environment. Operating manual: FRWM-AR Alarm relay...
-
Page 9: Overview
3 Overview 3.1 Function to a ventilation system • to a sprinkler system A FRWM-AR which is integrated into a radio • group, has a similar operation to a FRWM. If to a lighting installation • an alarm is triggered in a main or subgroup, or to other external devices •... - Page 10 1 and 100 mA to the relay (alarm out- 5. Configuration button: Using the sup- put with changeover contact (NC/NO)). plied split pins, you can configure the FRWM-AR by gently pressing the button. 1.1 NC (normally closed) 1.2 COM (ground) 1.3 NO (normally opened) 2.
-
Page 11: Putting Into Operation
Maintain an approximately equal distance One possible way to use the alarm input between the shared radio group and other of your FRWM-AR is the use of a manual radio groups push-button alarm. If this button is pressed, it f Install additional equipment, if also activates the FRWM-AR. - Page 12 • circuit to the alarm input which does not exceed the switching threshold the voltage drops below the switching • of 1.6 V or bridge the contact without threshold of 1.6 V. applying a voltage. Operating manual: FRWM-AR Alarm relay...
- Page 13 4.3 Integrating into a radio group For all further steps, the FRWM-AR must be in its delivery condition. The FRWM-AR cannot be the master in a radio group. Therefore, to integrate the f If this is not the case, follow the inst- FRWM-AR, at least one FRWM must be ructions listed under point 7 "Restoring...
-
Page 14: Connectivity
You cannot set a radio group into • learning mode via the FRWM-AR! 5 The connection test is then successfully ended. Using the FRWM-AR, the alarm of a • radio group cannot be muted or ended. Operating manual: FRWM-AR Alarm relay... -
Page 15: Restore Default Status
7 Restore default status (1) To set the FRWM-AR into default status, (2) Now release the button. press and hold the configuration button (3) The Status-LED lights up green briefly. for approx. 20 seconds. During these 5 The device is now in the default 20 seconds, the LED produces various status. -
Page 16: Alert Tones And Alarm Signals
FRWM-AR and the FRWM and a participant in the radio group has radio alarms produce a single beep at short been lost, the FRWM-AR, as well as all other intervals. connected FRWMs, produces a triple-beep at regular intervals. -
Page 17: Faults/Error Messages
9 Faults/error messages Possible faults when integrating FRWM-AR not in the default status into the radio group: If the FRWM-AR is not in the default status, All faults are indicated by the Status-LED flas- please follow the instructions under 7 "Restore hing red briefly. default status"on page 33. Possible fault causes:... -
Page 18: Packaging, Transport And Storage
5 °C and 35 °C. If you want to store the device for a longer period of time, please observe the following: The relative humidity (non-condensing) must be a max. of 70 % during operation. Operating manual: FRWM-AR Alarm relay... -
Page 19: Maintenance
FRWM-AR is still integrated in the radio group. waste disposal company, or to the return faci- 12.1 Visual inspection lities established by the manufacturer. -
Page 20: Accessories, Spare Parts & Service
3 V to 30 V at +49 2355 806 0. DC and/or AC 1 to 100 mA Peripheral cable with single wire wire cross-section between 0.5 and 2.5 mm² Radio frequency 868.3 MHz Ambient temperature 5 ... 35 °C Operating manual: FRWM-AR Alarm relay... - Page 21 Platz für Notizen Place for notes...
- Page 22 Impressum ALBRECHT JUNG GMBH & CO. KG © ALBRECHT JUNG GMBH & CO. KG Volmestraße 1 58579 Schalksmühle Stand der Betriebsanleitung 2018-02 Deutschland, Germany Revision of the operating manual 2018-02...
Need help?
Do you have a question about the FRWM-AR and is the answer not in the manual?
Questions and answers