Advertisement
CONTROL SWITCH OPERATIONS
WARNING: Keep fingers clear of rope and base when
operating. Do not operate in normal use with cover off.
Three position rocker control switch has UP, DOWN and OFF positions. DOWN powers the anchor down.
The gear motor automatically stops when anchor touches bottom. With the control switch in DOWN position,
electronic anti- drag system lets out necessary slack to prevent anchor drag. The OFF position locks gear
motor and rope. The UP position powers anchor up and retracts anchor into the DeckHand base. Releasing
the control switch automatically switches to OFF and secures anchor and anchor rope.
CIRCUIT BREAKER OPERATION
The power control circuitry and gear motor are protected by a manual resettable circuit breaker. Should
an operational situation occur where a prolonged overload is present the circuit breaker will disconnect the
battery positive supply in approximately ten seconds. The circuit breaker needs to be manually reset by
pushing the small black button on the side. Repeated tripping of the circuit breaker indicates an operational
or equipment fault that requires correction.
MAINTENANCE
• After use, rinse unit in fresh water and wipe down unit with a damp cloth.This unit is not intended
for saltwater use. Saltwater use will void your warranty.
• For prolonged storage, lightly coat metal parts with silicone spray or similar product.
• Avoid spraying switch components with any cleaning, lubricating or moisture absorbing com-
pounds. Check rope periodically for frays or cuts and replace if necessary.
TROUBLESHOOTING
1. Unit fails to operate or lacks power:
• Check circuit breaker, be sure button is pressed. If circuit breaker is tripped, investigate the
cause of the problem before resetting.
• Check battery charge and connections. Be sure terminals are clean and corrosion free. Use a
fine grade of sandpaper or emery cloth to clean terminals.
• Check your batteries water level. Add water if needed. If connections are good and battery has
a full charge, obtain service as instructed.
2.
Alternate Anchors:
• When using alternate anchors and davits insure that your anchor slides or rolls freely. Lubricate
rollers or pulleys if necessary.
3.
Anchor does not go down:
• Check circuit breaker, be sure button is pressed.
• Check battery connections.
Learn more about anchors on our website.
Advertisement
