Advertisement

ENVIRONMENTAL COMPLIANCE STATEMENT:
It is the intention of Johnson Outdoors Marine Electronics, Inc. to be a responsible corporate citizen, operating in compliance with
known and applicable environmental regulations, and a good neighbor in the communities where we make or sell our products.
WEEE Directive:
EU Directive 2002/96/EC "Waste of Electrical and Electronic Equipment Directive (WEEE)" impacts most distributors, sellers, and
manufacturers of consumer electronics in the European Union. The WEEE Directive requires the producer of consumer electron-
ics to take responsibility for the management of waste from their products to achieve environmentally responsible disposal during
the product life cycle.
WEEE compliance may not be required in your location for electrical & electronic equipment (EEE), nor may it be required for EEE
designed and intended as fixed or temporary installation in transportation vehicles such as automobiles, aircraft, and boats. In
some European Union member states, these vehicles are considered outside of the scope of the Directive, and EEE for those
applications can be considered excluded from the WEEE Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product must not be disposed of with other household refuse. It must be
disposed of and collected for recycling and recovery of waste EEE. Johnson Outdoors Marine Electronics, Inc. will mark all EEE
products in accordance with the WEEE Directive. It is our goal to comply in the collection, treatment, recovery, and environmen-
tally sound disposal of those products; however, these requirement do vary within European Union member states. For more
information about where you should dispose of your waste equipment for recycling and recovery and/or your European Union
member state requirements, please contact your dealer or distributor from which your product was purchased.
Disposal:
Minn Kota motors are not subject to the disposal regulations EAG-VO (electric devices directive) that implements
the WEEE directive. Nevertheless never dispose of your Minn Kota motor in a garbage bin but at the proper
place of collection of your local town council.
Never dispose of battery in a garbage bin. Comply with the disposal directions of the manufacturer or his repre-
sentative and dispose of them at the proper place of collection of your local town council
DÉCLARATION DE CONFORMITÉ ENVIRONNEMENTALE :
Johnson Outdoors Marine Electronics, Inc. a l'intention d'être une corporation responsable, fonctionnant en conformité avec les
règlements environnementaux connus et applicables, et d'agir en tant que bon voisin dans les communautés où nous fabriquons
ou vendons nos produits.
Directive WEEE :
La Directive 2002/96/EC de l'Union européenne traitant des déchets d'équipement électriques et électroniques, soit "Waste of
Electrical and Electronic Equipment (WEEE)", affecte la plupart des distributeurs, vendeurs et fabriquants de produits électron-
iques dans l'Union européenne. La directive WEEE demande que le fabriquant de produits électroniques se charge de la gérance
des déchets provenant de leurs produits afin de s'en débarrasser d'une manière responsable par rapport à l'environnement au
cours du cycle de vie du produit.
Respecter la directive WEEE peut ne pas être exigé où vous vous trouvez en ce qui concerne l'équipement électrique et électron-
ique (EEE), comme ne pas être exigé pour l'équipement électrique et électronique conçu et destiné à des installations temporai-
res ou permanentes dans les véhicules de transport comme les automobiles, avions et bateaux. Dans quelques pays membres
de l'Union européenne, ces véhicules sont considérés comme au-delà des limites de la directive et l'équipement électrique et
électronique pour ces applications peut être considéré exclus des exigences de la directive WEEE.
Ce symbole (roue WEEE) sur un produit indique que le produit ne doit pas être jeté parmi les déchets domestiques. Il doit être mis
au rebut et ramassé pour le recyclage et la récupération de déchet d'équipement électrique et électronique.
Johnson Outdoors Marine Electronics, Inc. marquera tout équipement électrique et électronique selon la direc-
tive WEEE. Nous avons pour but de respecter le ramassage, le traitement, la récupération et la mise au rebut
raisonnable par rapport à l'environnement de ces produits ; néanmoins, ces exigences varient parmi les pays
membres de l'Union européenne. Pour plus de renseignements sur où mettre au rebut les déchets de votre
équipement afin de les recycler ou les récupérer et/ou sur les exigences de votre pays membre de l'Union
européenne, veuillez contacter le concessionnaire ou distributeur de qui vous avez acheté le produit.
Disposition :
Minn Kota les moteurs ne sont pas soumis aux règlements de disposition EAG-VO (la directive d'artifices électrique) qui exécute
la directive WEEE. Ne débarrassez-vous quand même jamais de votre Minn Kota le moteur dans une boîte d'ordures, mais à
l'endroit nécessaire de collection de votre conseil municipal local.
Ne débarrassez-vous jamais de la batterie dans une boîte d'ordures. Pliez-vous aux directions de disposition du fabricant ou de son
représentant et débarrassez-vous d'eux à l'endroit nécessaire de collection de votre conseil municipal local.
© 2010 Johnson Outdoors Marine Electronics, Inc.
p/n 2377112
REV. I ECN 34823
05/13
NOTE: Do not return your DECKHAND to your retailer. Your
retailer is not authorized to repair or replace this unit. You
may obtain service by:
• calling MINN KOTA at 1-800-227-6433
• returning
Factory Service Center,
• sending or taking your DECKHAND to any MINN KOTA
authorized service center.
Please include proof of purchase, serial number and
purchase date for warranty service with any of the above
options.
REMARQUE : Ne retournez pas votre guindeau DECKHAND
à votre détaillant. Votre détaillant n'est pas autorisé à réparer
ou remplacer cette unité. Vous pouvez obtenir de l'aide en :
• appelant MINN KOTA au 1-800-227-6433
OWNER'S MANUAL
• retournant votre guindeau Deckhand au centre de service
MODE D'EMPLOI
après-vente en usine MINN KOTA
• envoyant ou amenant votre guindeau DECKHAND à un centre
de service après-vente MINN KOTA agréé compris sur la liste
Serial Number DH
ci-jointe.
Nº de série
Veuillez inclure un justificatif d'achat, le numéro de série et la
Purchase Date
date d'achat pour la réparation sous garantie quand vous choi-
Date d'achat
sissez l'une des options mentionnées ci-dessus.
DECKHAND 15
CAUTION: Read Manual
DECKHAND 25
Carefully Before Operating
Your New MINN KOTA
ELECTRICAL CONNECTIONS
DECKHAND. Retain For
TESTING / OPERATION
Future Reference.
OPERATION
PRÉCAUTION : Lisez attenti-
MAINTENANCE
vement ce manuel avant d'uti-
SCHEMATIC
liser votre nouveau guindeau
PARTS LIST
MINN KOTA DECKHAND.
LIMITED WARRANTY
Gardez-le pour vous y reporter
à l'avenir.
DeckHand
Models:
Modèles :
DH 15
DH 25
your
DECKHAND
to
the
MINN
KOTA
DECKHAND 15
pg.2-4
DECKHAND 25
pg.5-9
CONNEXIONS ÉLECTRIQUES
pg.10-11
ESSAIS / FONCTIONNEMENT
pg.12
FONCTIONNEMENT
pg.13-14
ENTRETIEN
pg.15
SCHÉMAS
pg.16-17
LISTE DES PIÈCES
pg.18
GARANTIE LIMITÉE
pg.19

Advertisement

Table of Contents
loading

Summary of Contents for MINN KOTA DeckHand DH 15

  • Page 1 Minn Kota les moteurs ne sont pas soumis aux règlements de disposition EAG-VO (la directive d’artifices électrique) qui exécute Future Reference. OPERATION FONCTIONNEMENT la directive WEEE. Ne débarrassez-vous quand même jamais de votre Minn Kota le moteur dans une boîte d’ordures, mais à pg.13-14 PRÉCAUTION : Lisez attenti- MAINTENANCE ENTRETIEN pg.15...
  • Page 2 • or to any authorized MINN KOTA service center listed on the enclosed sheet. drilling. Drill through the marked holes using NOTE: Do not return your MINN KOTA Deckhand or parts to your retailer.Your retailer is not authorized to repair or replace this unit. ” drill bit.
  • Page 3 Item Part Description 2370206 Cover DH-15 w/ decals 2370207 Cover DH-25 w/ decals FILLING THE ANCHOR ON THE DH-15 2372121 Screw-#8-18x 1-1/2 Stallgrd (2 .ea) 2372111 Screw-#8-18x 3/4 Stallgrd (2 .ea) Your DeckHand anchor must be filled with steel shot (not provided). It is recommended to use 2377803 Motor Assembly - DeckHand- Includes 6-13 a shot size of #6 through #9.
  • Page 4 ATTACHING THE ANCHOR ON DH-15 Your DeckHand Electric anchor winch is spooled with sixty-feet of 3/16” diameter rope. The use of smaller diameter or alternate style ropes is not recommended. Release free end of rope from spool (15), unroll a minimum of three-feet from the spool.
  • Page 5 INSTRUCTIONS FOR DH-25 NOTE: Numbers in ( ) are item numbers referring to parts diagram. A. Winch and Davit mounted together 1. Remove DeckHand cover (1) by removing cover screws, items (3) and (4). 2. Place the base (18) and the davit (53) in your desired mounting location. Make sure that when the DeckHand is operating or in a stowed position, the anchor does not come in contact with the boat.
  • Page 6: Maintenance

    NOTE: Do not install opp. Sleeve Roller (56) until after Davit (53) has been MAINTENANCE mounted to boat using the four mounting bolts provided. • After use - particularly in salt or brackish water, rinse unit in fresh 4. Once drilled, mount the base using the mounting hardware ( water and wipe down unit with a damp cloth.
  • Page 7: Circuit Breaker Operation

    Make sure there are no obstructions under the mounting surfaces CONTROL SWITCH OPERATIONS prior to drilling. Drill through the marked holes made from base using a ” drill bit, through the marked hole made from davit using a ” drill bit. WARNING: Keep fingers clear of rope Also drill through the marked hole beneath the rear davit pulley with a ”drill...
  • Page 8 Spool and rope assemblies may be purchased direct from Minn Kota or autho- rized Minn Kota Service Centers. Should you decide to replace your own rope, it 1. Release free end of rope from spool (15). Unroll a minimum of four feet is recommended to use a ”...
  • Page 9: Function Test

    FUNCTION TEST LOCKING PIN OPERATION FOR DH-25 1. With attached anchor hanging over edge of boat, turn control switch to 1. Your davit is provided with a locking safety pin that is fastened to the “UP” position. Anchor should retract into base on DH-15 or into davit on davit.
  • Page 10: Battery Connections

    BATTERY CONNECTIONS CAUTION: 1. Center control switch in • Improper polarity hook-up of bat- “Off” position. tery leadwire could cause severe 2. Connect DeckHand damage to gear motor. leadwire to 12V battery. If • The DeckHand is provided with additional leadwire length is a sealed control switch and circuit needed, use a minimum of 10 breaker.
  • Page 11: Repair And Troubleshooting

    AUTHORIZED SERVICE CENTERS Minn Kota has over 300 authorized service centers in the United States and Canada where you can purchase parts or get your products repaired. Please visit www.minnkotamotors.com and click on “Service Center Locator” under the “Service” tab to locate a service center in your area.
  • Page 12 NOTES NOTES...

This manual is also suitable for:

Deckhand dh 25

Table of Contents