Table of Contents
Advertisement
INSTALLATION
Separate the two keypad halves by carefully inserting a small screwdriver into the release slots on the bottom
edge of the keypad front half and applying a gentle pressure. This will release the bottom edge of the housing
enough for you to unclip the top.
Screw the base to the wall using the mounting holes provided. These holes will match the standard single switch
plate spacing. Ensure the base is mounted right side up. It is marked with the word "TOP" to aid orientation.
When fixing the base to the wall make sure the top of the screw heads will not touch or short out the underside
of the PCB when the top half of the keypad is reinstalled. Bring the cables through the centre of the base.
Connect the 4 or 5 wires to the 5 way terminal block on the rear of the keypad PCB making sure to match the
cables up with the terminals as marked on the control panel's keypad port. The 5th wire is connected from the
"LIN" terminal of the keypad to the "Listen" terminal of the Alert PCB keypad port.
Once the cables have been terminated and the required address allocated (see section below) clip the front half
of the keypad onto the base by first engaging the clips at the top edge and then close the front down and clip it
in at the bottom. Now stick the zone list provided to the inside of the hinged lid.
WIRING
The Elite keypad connects to the Elite Controller via a 4 or 5 wire data security cable. A maximum of 8 LED
keypads can be connected, each wired in parallel. A 5th wire may be used to provide a "Listen-in" facility at the
keypad when an Elite communicator panel is being used.
The maximum recommended cable using standard 0.2mm security cable is 50m. Cable runs exceeding this
distance may require 0.5mm cable. Always use good quality cable. Some installations may require CAT5 data
cable to ensure data integrity in noisy sites.
Keypad
Address
#
A
1
X
2
3
X
4
5
X
6
7
X
8
X denotes link is cut
Address
Each of the 8 possible LED keypads which are able to be connected to
Links
your Elite panel must be addressed individually to avoid BUS conflicts
when multiple users are operating different keypads simultaneously.
B
C
As default, each keypad comes addressed as #1 with all links intact.
Use the table to the left to determine which links to cut to assign the
correct address to the keypads you are installing.
eg. To assign a keypad as address #2, you must cut link A only. To
X
assign a keypad as address # 4, you must cut link A&B.
Link D is used to modify the keypad "Panic" button operation. When
X
the link is intact, the "Panic" button must be held down for 2 seconds to
cause a Panic alarm. If link D is cut the "Panic" button is instant.
X
When cutting address links it is important to make a clean cut between
X
the link blocks as shown below. Links can be restored by soldering
across the effected pads.
X
X
IMPORTANT NOTE: KEYPAD ADDRESS CHANGES ARE ONLY
RECOGNISED AT POWER-UP. ALL CHANGES SHOULD BE MADE
X
X
IN THE POWERED DOWN STATE AND THEN ON POWER-UP THE
NEW KEYPAD ADDRESS WILL BE RECOGNISED BY THE PANEL.
KEYPAD INSTALLATION
KEYPAD ADDRESS ASSIGNMENT
A
Page 10
B
C
D
cut here
Hide quick links:
Advertisement
Table of Contents
