Connecting The Megaplug Adapter; Connecting The Adapters - ActionTec HPE100T User Manual

Connecting the
MegaPlug Adapter
To connect the Adapter, it must be connected to a computer, plugged into a stan-
dard wall outlet, and the Configuration Utility loaded on the computer.

Connecting the Adapters

To use the Adapters properly, two Adapters should be plugged into electrical out-
lets, and devices (computers, printers, etc.) connected to them.
Connecting an Adapter to a Computer
1. Get an Adapter and one Ethernet cable.
2.
Insert one end of the Ethernet cable into the Ethernet port of the Adapter.
3. Plug the Adapter into a wall outlet.
☞
Note: Do not plug the Adapter into a
surge protection. The Adapter's network signal may not pass
through these devices.
4. Insert the other end of the Ethernet cable into an Ethernet port on the back of
a computer.
Connecting an Adapter to a Router/Gateway
1. Get an Adapter and one Ethernet cable.
2.
Insert one end of the Ethernet cable into the Ethernet port of the Adapter.
3. Plug the Adapter into a wall outlet.
☞
Note: Do not plug the Adapter into a
surge protection. The Adapter's network signal may not pass
through these devices.
4. Insert the other end of the Ethernet cable into an Ethernet port on a router/
gateway connected to a computer.
or power strip with
UPS
or power strip with
UPS
5
2