Philips HR2067 User Manual page 10

ENGLISH
10
Never let the mill run for more than 30 seconds without interruption.
Citrus press (HR2066 only)
Preparing the citrus press for use
1 Put the gear unit of the citrus press in the bottom of juice jug (1) and turn it clockwise until
it snaps into position (2) (fig. 14).
2 Place the sieve in the juice jug. Push it down (1) and turn it clockwise until it snaps into
position (2) (fig. 15).
3 Place the cone onto the driving shaft in the centre of the sieve (fig. 16).
4 Assemble the citrus press onto the motor unit by turning it clockwise until it locks into
position (fig. 17).
Using the citrus press
1 First set the control knob to speed 1 and then press the citrus fruit onto the cone.
2 Stop pressing from time to time to remove the pulp from the sieve.
Do not exceed the level indication on the juice jug.
3 When you have finished pressing or when you want to remove pulp, switch the appliance off
and remove the juice jug with the sieve and cone on it by turning it anticlockwise.
4 To disassemble the citrus press, remove it from the motor unit by turning it anticlockwise.
Then remove the cone, the sieve and the gear unit.
Cleaning
Always unplug the appliance before cleaning it.
Tips:
- Cleaning the appliance and its parts is easiest immediately after use.
- If necessary, the mesh of the filter may be cleaned with a very soft brush.
- Always disassemble all removable parts before cleaning them.
Do not use abrasives, scourers, alcohol, etc.
See the cleaning table at the end of these instructions for use for further instructions.
Quick-cleaning the blender jar
1 Fill the blender halfway with warm water and add a few drops of washing-up liquid.
2 Turn the control knob to the pulse setting a few times.
3 Detach the blender jar, empty it and rinse it under the tap.
Storage
Store the mains cord by winding it round the reel in the bottom of the appliance (fig. 18).
Environment
Do not throw the appliance away with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this you will help to preserve
the environment (fig. 19).