Gigabyte G481-H80 Service Manual page 61

Parameter
Advanced NIC
Configuration
UEFI Driver
Device Name
PCI Device ID
PCI Address
Port GUID
Fabric Link State
Fabric Link Speed
Fabric Link Width
Description
Press [Enter] to configure advanced items.
Debug Options
Š
– Allows users to configure link initialization in pre-boot.
– Options available: Auto/Enabled/Disabled. Default setting is Auto.
Use a custom P_Key value
Š
– Select 'Yes' to use a custom P_Key value or boot over fabric (instead of a
default one.)
– Options available: No/Yes.
Custom P_Key value (hexadecimal)
Š
– This item cannot be configured if Use a custom P_Key value is set to No.
– This P_Key value will be used for boot over fabric. The 'full membership' bit
(0x8000) will be always set automatically.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
Displays the technical specifications for the Advanced Network Interface Controller.
- 61 - BIOS Setup