Table of Contents
Advertisement
DasyLab Platinum Modbus Interface
3.3.2 TCP/IP Interface
In this example, Modbus communication to Platinum is through TCP/IP interface. The TCP
communication protocol needs to be changed to ModbusTCP. This setting can be found on
Communication page/Network Connection Configuration section. The default device IP address of
Platinum's TCP/IP interface is 192.168.1.200 and the default Modbus Local Port is 502.
Platinum Ethernet communication protocol also needs to be changed to Modbus/RTU. This setting is
accessible through the front panel menu /INIT/COMM/ETHN/PROT.
The setup procedure for DasyLab Modbus over TCP/TIP is similar to DasyLab Modbus Serial. The
following screenshot illustrates a typical configuration.
Document Number
For Internal Use Only: This document contains confidential, proprietary information of Omega Engineering/Newport Electronics,
The Document may not be copied or reproduced without the prior, written permission of Omega Engineering/Newport Electronics
Revision 1.0
Page 11 of 11
Advertisement
Table of Contents
