i-MARK Installation and Hardware Manual
2
Introduction
Compact Unit i-MARK 2
2.1
Preparations
This installation manual must be read carefully prior to starting the installation. The described
installation work assumes that installation materials like cable, antenna and data tag holder etc are
available
2.2
Scope of This Document
This document is the hardware description of both the i-MARK 2 and i-MARK 3. This document is
intended only for mechanical and electrical installation of this central units. A general system
description, especially of the Position Marker technology can be found in the extra system description;
please see below.
2.3
Responsibility
IDENTEC SOLUTIONS is not responsible for any errors occurring in this document.
Central unit i-MARK 3
Page 9 of 22