Page 2
Proprietary Notice This document contains confidential information proprietary to IDENTEC SOLUTIONS and may not be used or disclosed to other parties in whole or in part without prior written authorization from IDENTEC SOLUTIONS. Disclaimer and Limitation of Liability IDENTEC SOLUTIONS AG and its affiliates, subsidiaries, officers, directors, employees and agents provide the information contained in this Manual on an “as-is”...
Wristband Tag Manual Radio Frequency Compliance Statement FCC Compliance This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
An additional performance check of the tags and a system test can now be done Scope of this Document This document is the user’s manual of the model i-B2X W tag. This document is intended only for mechanical installation rsp. everyday use.
Check delivery whether it is complete and for any damages. If the delivery is not complete or damaged immediately inform the carrier. The dispatch and service organization of IDENTEC SOLUTIONS should also be informed to facilitate the repair or exchange of the system.
W Initial Operation Important Note Do not open the housing! Configuration is done using the built-in air interface of the i-B2X W. Configuration The i-B2X W is configured using the i-PROG MB programming device. Things to be configured •...
Wristband Tag Manual Tag Mounting Techniques The tag is carried as every standard wristwatch. The band should not be too loose. This avoids that the tag slides down over the wrist and prevents possible injury. For maximum convenience put the end of the wristband under the loop. Now adjust the loop to avoid too much of the band to stick out.
W Maintenance General In principle, the ILR system is maintenance-free. When correctly installed it operates for many years without any problems. Precautionary Maintenance Regular checking to the system is recommended. Make sure that the housing of the tag has no damage. If there are any damages as holes or cracks, the tags should be replaced and returned to IDENTEC SOLUTIONS immediately.
Wristband Tag Manual Technical Data Operating Data Long-Range RFID (ILR, Beacon Technology) Read range Up to 30 m (90 ft) in free air Operating frequency 868 MHz (EU) or 915 MHz (NA) ISM band Operation mode Transmits a pre-programmed data string in regular intervals Repetition rate (ping rate) 0,5 –...