Saving Parameters; Device Control - Televes MUX DVBS2 - QAM CI Twin User Manual

5.3 Saving parameters

After setting up the unit by means of the two
menus available, main and extended, all data will
be saved by pressing the button
seconds.
The display shows:
Do not remove the programmer before the
message disappears from the screen.
If configuration data are changed but not saved,
previous settings will be restored after about 30
seconds. Therefore all changes made would be
canceled.

6. Device control

This version of modules allows configuration and
for about 3 monitoring via a PC, both locally and remotely.
a. Local control
The "Headend Management" software (v2.14.40
or higher) is required, as well as a special lead
(provided with the software) that connects a PC
serial port to the "PRGM" socket of the MUX DVBS2-
QAM/COFDM CI T.0X unit.
The software can be used to set up and read all the
operating parameters, as well as to monitor the
correct operation of the device.
b. Remote control
It is necessary to have a Headend Control module
(Ref. 5559 or 555901) that includes the above
mentioned software.
Once the communication with the headend
control has been established, all the controllable
devices that have been installed in the headend
can be accessed. In this case it is imperative that
each module is programmed with a different
device address selected between 1 and 254.
25
EN