Micro-Adjustable Head Microkom Bluflex® 2 - Komet MicroKom BluFlex 2 Operating Instructions Manual

KOMET MicroKom BluFlex ® 2
The tool is usually operated as follows:
- Fit boring bars, serrated bodies or bridges with cutting edge holders and
inserts with the MicroKom BluFlex ® 2 precision adjustment head.
- Always use the specified tightening torques
- Before adjusting the slide, loosen the clam-
ping screw, adjust the slide, release the
tension slightly and then clamp.
Note: Always use a clamping torque of 8 Nm.
- Preset the cutting edge position in absolute
mode
- Adjust the premachining diameter on the
tool presetting device
- Always put all the screws in lightly (risk of
flying off)
- Always remove the adjustable spanner and
clamping spanner after adjustment and
before start-up
- Make the hole
- Measure
- Set precision adjustment in difference mode
Micro-adjustable head with ABS50 connection
1
Slide
2
Clamping screw for slide
3
Adjusting screw for slide
4
Coolant outlet (see page 27)
5
Balance compensation
6
Battery compartment
7
Screws for tool clamp
8
9 (see page 26)
Touch display and confirmation
J
20
2
8
9
J
6
5
7
3
4
1