Table of Contents
Advertisement
To clean the burner head ignition ports
Each burner head has a small ignition port located as shown.
Should you experience ignition problems it may be that this port
hole is partially blocked with soil. With the burner head in
place, use a small wire gauge needle or the end of a paper clip
to clear the ignition port.
slots
ignition port
ignitor
Important notes:
•
The surface burner heads are secured to the cooktop and
must be cleaned in place on the cooktop.
•
Always keep the surface burner caps in place whenever a
surface burner is in use.
•
When replacing the burner caps, be sure the burner caps
are seated firmly on top of the burner heads.
•
For proper flow of gas and ignition of burners do not allow
spills, food, cleaning agents or any other material to enter
the gas orifice port opening.
orifice port
23
Replacing oven light (some models)
Be sure the range is unplugged and all parts
are cool before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass.
The oven light is located at the rear of the oven cavity and is
covered with a glass shield held by a wire holder. The glass
shield protects the light bulb and must be in place whenever the
oven is in use.
glass
shield
wire
holder
Figure 15: Replacing the oven light
To replace the interior oven light bulb:
1.
Turn electrical power off at the main source or unplug the
range.
2. Press wire holder to one side to release the glass shield that
covers the light bulb.
3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder back
into place.
5. Turn power on at the main source (or plug the appliance in).
6. The clock will then need to be reset. To reset, see
Clock"
on
page
16.
"Setting
Hide quick links:
Advertisement
Table of Contents
