Setup Procedures; Quick Setup List - Snapper 5201E Dealer Setup & Adjustment Instructions Manual

Quick Setup List -

Page Setup Procedure
4 Unbox & Assemble
5 Fill Gas Tank
6 Lubricate Snowthrower
7 Test Run
Additional information concerning functional
tests, general adjustment procedures, and
the location of normal lubrication points are
included in these instructions.
Although all required lubrication and normal adjust-
ments on factory-assembled components are done at
the factory, this additional information is provided to
assist you in ensuring that each unit is delivered to the
customer in proper working order.
5/2005
520 Single Stage Snowthrower
Steps to Perform
❏ Remove Unit From Box.
❏ Install Discharge Chute
❏ Assemble Handle Bars
(Be careful not to pinch the auger cable)
❏ Mount Clean-Out Tool in storage position
on handle
❏ Fill Gas Tank
❏ Lubricate all grease & oil points
❏ Check Primer
❏ Check Choke
❏ Check Recoil Starter
❏ Check Electric Starter (Where Applicable)
❏ Check Auger Control Cable
❏ Check Kill Switch
❏ Check Chute Rotator
❏ Check Deflector
3