Cisco uBR924 Configuration Manual page 28

cable-modem compliant bridge
cable-modem compliant bridge
To enable DOCSIS-compliant transparent bridging for a cable access router interface at startup, use
the cable-modem compliant command from interface configuration mode. Use the no form of this
command to disable DOCSIS-compliant bridging for the interface.
cable-modem compliant bridge
no cable-modem compliant bridge
Syntax Description
This command has no arguments or keywords.
Defaults
Enabled
Command Modes
Interface configuration
Command History
Release
11.3 NA
Usage Guidelines
It is normally not necessary to enter this command in data-over-cable bridging applications because
DOCSIS-compliant bridging is enabled by default. If you wish to do full transparent bridging rather
than DOCSIS-compliant bridging, use the no form of the command, then configure full transparent
bridging using CLI commands. See the "Configuring Bridging" section on page 16 for instructions.
Examples
The following example shows how to enter the cable-modem compliant bridge command for a
cable access router interface, starting from global configuration mode:
uBR924(config)# interface cable-modem 0
uBR924(config-if)# cable-modem compliant bridge
uBR924(config-if)#
28 Cisco IOS Release 12.0(5)T
Modification
This command was first introduced.