Operation; Maintenance - Craftsman 315.114073 Operator's Manual

See Figures 1 - 3, page i.
WARNING:
If any parts are damaged or miss-
ing do not operate this product until the parts are
replaced. Use of this product with damaged or miss-
ing parts could result in serious personal injury.
WARNING:
Do not stare into the light (not even
from a distance). Staring into the light beam may
result in serious injury or vision loss.
WARNING:
When hanging the fluorescent light
by its hanging/storage hook, always be sure it is
securely in place to prevent the light from falling.
Failure to do so could cause serious personal injury
or damage to the light if the light falls.
CAUTION:
When placing the battery pack in the
tool, be sure raised rib on battery pack aligns with
the groove in the tool and that the latches snap into
place properly. Improper assembly of the battery
pack can cause damage to internal components.
BATTERY PROTECTION FEATURES
Craftsman® 19.2 V lithium-ion battery packs are designed
with features that protect the lithium-ion cells and
maximize battery life.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
may result in serious personal injury.

OPERATION

If the tool stops during use, recharge the battery pack.
BULB REPLACEMENT
Replace the fluorescent tube (bulb) with the same type
rated 19.2 V, 13 watt.Always ask for replacement bulb
number
TO REPLACE FLUORESCENT TUBE:
 Remove the battery pack from the worklight.
 Remove the screw to release the lens cover. Remove
the lens cover by pulling the cover forward and lifting it
from the housing.
 To remove the old fluorescent tube from the spring,
gently grasp the lower edge of the rubber cushion and
the sides of the bulb. Carefully work the tube in a side-
to-side motion while easing the tube forward and up
until the tube is free from the spring.
NOTE: Do not pull the fluorescent tube straight
out from its center, as this increases the chance of
breakage.
 Remove the rubber cushion from the old fluorescent
tube and place it on top of the new tube, rounded edge
facing outward.
 Insert the new fluorescent tube into the spring by
aligning the prongs on the tube with the holes in the
tube socket area. Gently push down on the base of the
new tube until fully engaged. Do not force the tube into
place.
 Replace the lens cover by sliding the lower edge
into the housing. Align the screw holes at top. With a
screwdriver, tighten the screw.
NOTE: Do not use a drill to tighten the screw, as the
drill's torque may be strong enough to damage the lens
cover.
 Replace the battery pack.

MAINTENANCE

BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
WARNING:
pack's terminals with heavy-duty adhesive tape. Do
not attempt to destroy or disassemble battery pack
or remove any of its components. Lithium-ion and
nickel-cadmium batteries must be recycled or dis-
posed of properly. Also, never touch both terminals
with metal objects and/or body parts as short circuit
may result. Keep away from children. Failure to
comply with these warnings could result in fire and/
or serious injury.
5 - English
7819602.
Upon removal, cover the battery