Table of Contents
Advertisement
Installation Instructions
1
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and standards in force in the country of use are to be
followed (safety regulations, proper recycling in accordance with the regulations, etc.)
Installation may only be carried out by a qualified electrician.
The minimum distances to other appliances and units are to be observed.
Anti-shock protection must be provided by the installation, for example drawers may
only be installed with a protective floor directly underneath the appliance.
The cut surfaces of the worktop are to be protected against moisture using a suitable
sealant.
The sealant seals the appliance to the work top with no gap.
1
Important: If the down draught extractor is operated at the same time as a gas appli-
ance, there must be sufficient draught in the room.
1
Important: If the down draught extractor is operated at the same time as a fireplace, the
pressure in the room must be below 4 Pa (4 x 10
1
Important: If the mains cable is defective, it must only be replaced by a qualified electri-
cian or our Customer Care Department in order to prevent hazards.
z
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing correctly.
• The appliance must be connected to the electrical supply by a qualified electrician.
z
Risk of injury from electrical current.
• Loose and inappropriate plug and socket connections can make the terminal overheat.
• Have the clamping connections correctly installed by a qualified electrician.
• Use strain relief clamp on cable.
A device must be provided in the electrical installation which allows the appliance to be
disconnected from the mains at all poles with a contact opening width of at least 3 mm.
Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to
be removed from the holder), earth leakage trips and contactors.
Connect down draught extractor to an air-tight vent hose or vent pipe with a 120 mm
diameter and at least 1 m long.
1
Important: Do not connect down draught extractor to the voltage supply until an ade-
quate air outlet has been provided.
Do not connect vent hose or vent pipe to an air shaft, flue or similar which is already in
use.
If several Frontline appliances are installed, install down draught extractor between the
appliances.
Distance from flammable materials: at least 150 mm
Installation Instructions
-5
bar).
11
Advertisement
Table of Contents
