Table of Contents
Advertisement
12
Installation Instructions
1
Important: Official regulations must be followed when drawing off exhaust air.
1
Important: Do not conduct exhaust air to a chimney which is used by appliances operat-
ed with gas or other combustible fuels.
Installing next to a gas appliance
1
Important: The appliance must not be built in between two gas appliances.
1
Important: If a gas appliance is installed next to the down draught extractor, the down
draught extractor may only extract air on the opposite side. Therefore the fin nearest the
gas appliance must be removed and the supplied cover must be fitted.
To remove the fin
1. Switch on down draught extractor and move to
the top position.
2. Switch off fan level.
3. Press in and remove the springs of the filter.
4. Take filter out.
5. Remove upper casing and place on something
soft.
6. Remove the two screws which hold the fin.
7. Remove single screw that holds the lever that
closes the fin.
8. Remove the fin.
To fit cover
1. Lay cover on the glass ceramic.
2. Position cover on the upper housing.
3. Mark four holes on the upper casing. Use cover
as a template.
4. Remove cover and drill the four holes in the
upper casing.
5. Remove adhesive film.
6. Press cover in position on the upper casing.
7. Affix cover with the blind rivets supplied.
8. Install filter, springs and upper casing in reverse
order.
Advertisement
Table of Contents
