Cisco Aironet 1430 Series Getting Started Manual page 26

Table 6 Bridge Normal Mode LED Indications (continued)
Ethernet Status
LED LED
— —
— —
The bridge uses a blinking code to identify various error conditions. The code sequence uses a
two-digit diagnostic code that starts with a long pause to delimit the code, followed by the LED
flashing red to count out the first digit, then a short pause, followed by the LED flashing red to count
out the second digit (see Table 7).
Table 7 Bridge LED Blinking Error Codes
Blinking Codes
First
LED Digit
Ethernet 2
Radio 1
1
1
1
1
26
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Radio Meaning
LED
Blinking Maximum retries or buffer full occurred on the radio
amber interface—disconnect and reconnect the power injector
power jack. If the problem continues, contact technical
support for assistance.
Amber Radio firmware error—disconnect and reconnect power
injector power.If the problem continues, contact technical
support for assistance.
Second
Digit Description
1 Ethernet cable problem—verify that the cable is properly
connected and not defective. This error might also indicate
a problem with the Ethernet link. If the cable is connected
properly and not defective, contact technical support for
assistance.
2 Radio not detected—contact technical support for
assistance.
3 Radio not ready—contact technical support for assistance.
4 Radio did not start—contact technical support for
assistance.
5 Radio failure—contact technical support for assistance.
6 Radio did not flash its firmware—contact technical support
for assistance.