ADEMCO 5804BD User Manual

General Information

The 5804BD is a four-button wireless key that permits an alarm system to be controlled remotely. It is a bi-directional
device, which means that it can send a command to the control, such as to arm or disarm, and can also receive status back
from the control, which is indicated by two bi-color status LEDs and a piezoelectric sounder. The 5804BD is typically
used for arming, disarming, panic, and output relay operation. Check with your installer for operation of the buttons on
your unit.
Operating the Buttons
To Activate a Button
To activate programmed function on a button, press and hold the button down until the yellow LED flashes (2 beeps will
be heard), and then release it.
To Request System Status
Since the 5804BD is a bi-directional device, users can check the system status before arming or disarming their system.
To check system status, press and release any button momentarily. The yellow LED will flash after you release the
button (1 beep will be heard). After a second or two, the 5804BD will display the system status information using a
combination of LED and sounder activity (see the System Status Indications Table, below). If 5804BD does not receive
system status information from the panel for approximately five seconds, it will generate a long (1 second) beep and shut
itself down. It will also shut itself down if there is no button activity within five seconds of receiving a status update.
LED
Red
Green
Yellow (right)
Red & Green
Green
Multiple Button Operations
The 5804BD can generate the same responses as keypad
panic key pairs of [*] + [#] and [*] + [1] by depressing
"A" + "C" and "B" + "D" button pairs, respectively.
You must depress the button pair for at least two seconds
for the 5804BD to recognize the button pair command.
These button pairs will allow the user to activate panic,
fire, and medical alarms depending on control panel
programming.

Low Battery Indication

When the unit goes into a Low Battery condition, the yellow LED will not flash when a button is pressed. Change both
batteries immediately.
86(5·6*8,'(
System Status Indications Table
LED Condition
On Steady
On Steady
Flashing
Flashing
Flashing
On Steady
Flashing
Flashing
Alternately Flashing
Flashing
Flashing
%'
%,',5(&7,21$/:,5(/(66.(<
Sounder System Status
2 Beeps Armed Away or Maximum
3 Beeps Armed Stay or Instant
Pulsing Fire Alarm in progress
Steady Armed, Burglary Alarm in progress
Silent Alarm Memory
1 Beep Disarmed, Ready to Arm
Silent Disarmed, Not Ready to Arm
Silent Indicates RF transmission .
Silent In Enter House ID Mode
Pulsing System in Trouble
Silent System Not Ready
N8547 01/97