ADEMCO 5805BDV Installation Instructions

General Information

The 5805BDV is a four-button wireless key that permits
the user to control the alarm system remotely. It is a two-
way device that sends commands (e.g., Arm, Disarm, Panic)
to the alarm system, and receives current status from the
system. Additionally, the unit contains a Message Mode
that allows the user to leave or retrieve voice messages.
Status is indicated by one bi-color status LED and a
speaker. Each button can be programmed for any zone
response type, but is typically used for arming, disarming,
panic, and output relay operation.
1. The 5805BDV must be used in conjunction with
one of the following:
N
5800TM (Transmitter Module) and a 5881 or
5881EN* receiver
N
6128RF keypad/transceiver, 6150RF, and
6160RF keypads
N
Lynx control panel.
2. Place the 5881 or 5881EN receiver and the
5800TM Transmitter Module in a high, centrally
located area for best reception. The 5800TM
module must be located between 1 and 2 feet
from the receiver.
* Must be used to activate High-Security mode.
The unit is powered by a single, replaceable, AAA battery
and designed to provide up to 2 years of life. The battery is
supplied with the unit but not installed (see "To
Install/Replace Battery" for more information).
Speaker
5805BDV Front View
Loop Assignments:
N
ON Button = Loop 3
N
1 Button = Loop 4
To Install/Replace Battery
On backside of unit, press the battery door down, then

push forward and pull up. NOTE: Be careful not to
activate any buttons while doing this.
Remove the old battery.

Place the AAA battery into battery compartment (see

diagram).
PRELIMINARY
2/26/03B..tp

INSTALLATION INSTRUCTIONS

LED
ON OFF
1 2
Microphone
N
OFF Button = Loop 2
N
2 Button = Loop 1
TWO-WAY WIRELESS KEY WITH VOICE
Observe polarity to prevent damage to the unit or
to the battery.
Programming the 5805BDV House ID
You must program a House ID number into the unit before
you can use it to display the system status. The House ID
number, in the range of 01 to 31, must be the same as
the one used in the control panel for each device. The
default House ID of the 5805BDV is 10.
To Program a House ID
Enter Programming mode by pressing the ON, OFF, and

1 buttons at the same time.
announcement stating "House ID Mode"
LED flashing red and green alternately.
Enter the House ID number by using the ON button to

enter the 10's digit and the OFF button to enter the 1's
digit.
Refer to the four examples below.
NOTE: If the digits entered are not within the range of
01-31, the unit will not accept the entry.
Accept the entry entered by pressing the 2 button.

The unit displays the stored number by flashing the red

LED for the 10's digit and flashing the green LED for the
1's digit (e.g., for House ID 21, the red LED will flash
twice, the green LED will flash once).
The unit will then automatically exit the House ID

programming mode.
If you enter an incorrect HID, you must start again from

step 1 above.
Example: To enter House ID # 17 into the unit:
1
Enter HID mode: Press ON + OFF + 1
buttons until LED flashes
3
To accept entry, press 2 button.
K5756 2/03
5805BDV

You will get an audio
with the
2
Enter HID #17: Press & release ON button
once, press & release OFF button 7 times.
4
HID will be shown by flashing LED.
Unit automatically exits HID.