INSTALLATION INSTRUCTIONS
General Information
The 5804BD is a four-button wireless key that permits an alarm system to be controlled remotely. It is a two-
way device, which means that it can send a command to the alarm system, such as to arm or disarm, as well
as receive status back from the control. Status is indicated by two bi-color status LEDs and a piezoelectric
sounder.
Each button can be programmed for any zone response type by using the alarm system's
transmitter "learn" mode. Typical use is for arming, disarming, panic, and output relay operation.
The 5804BD must be used in conjunction with a 5800TM (Transmitter Module) and 5881 RF Receiver.
The unit is powered by 2 replaceable Lithium batteries designed to provide up to 2 years of life (see "To
Install\Replace Batteries" for more information).
Loop Assignments:
• Button A =>Loop 3
• Button B =>Loop 2
• Button C =>Loop 4
•
Button D =>Loop 1
To Remove or Insert the Unit from Belt Clip
To Install/Replace Batteries
1. Remove the screw from the back case.
2. Remove case back by using the blade of a small screwdriver to pry
open.
3. Place batteries in case back locations, see diagram. Use CR2430 or
DL2430 Lithium battery only.
4. Close the case by snapping case front and back together.
5.
Replace the screw to secure the case.
Improperly installing the batteries will cause damage
to the batteries.
WARNING!
Programming the 5804BD House ID
You need to program a House ID number into the unit before you can to use it to display the system status.
The House ID number must be same as the one used in the alarm control. The House ID must be in the
range of 01 to 31. The default in the 5804BD is 10.
5804BD
BI-DIRECTIONAL WIRELESS KEY
Note: Place the 5881 receiver and
the 5800TM transmitter module in
a high, centrally located area for
best reception.
module must be located between
1 and 2 feet from the receiver.
Previous Menu
N8209V1 04/97
The 5800TM