Tantalus ITRON SENTINEL TUNet PP-1316 Install Manual page 10

5. Insert the Tantalus communications module ribbon cable between the two outer ridges. The
ribbon cable should fit snugly between the two ridges.
6. Firmly press the ribbon cable connector against the mating header underneath the Itron
SENTINEL® communications board. To ensure proper connectivity, verify that the ribbon
cable connector is inserted as shown in the following figure:
Note: If the connector was not engaged properly, there will be a visible row of crimps on the blue
ribbon cable connector, as shown in the following figure:
Page 6 Tantalus Systems Corp.
Released 18/09/2011