Setting The Clock - BlueLine PowerCost Monitor Manual

12/24 Used to switch clock between 12-hour and 24-hour display modes.
Reset Used in conjunction with SET button to return Display Unit to its
factory settings.
CLEAR Used to clear the total values.
MODE Used to switch between Dollar Mode and Kilowatt Mode.
LIGHT Used to light the screen.
7.2.

Setting the Clock

To set the correct time on your Display Unit, follow these steps (refer to
Figure 7.2):
1. Press-and-hold the SET Button located on the back of the Display
Unit until you hear a single beep (approximately 3 seconds). After
the beep, the hours portion of the clock will start flashing.
2. Press the + or - buttons to set the proper hour. Once the hours are
correct, press-and-release the SET button to advance to the minutes
setting.
3. Again, press the + or - buttons until the minutes are correct.
4. Press the SET button 3 more times to return to the main screen.
5. To switch time between 12-hour and 24-hour display modes press
the 12/24 button on the back of the Display Unit.