Advertisement
ASSEMBLY INSTRUCCIONS
Once the adaptor has been assembled you are then ready to t the TOP CASE.
tongue into the adaptor groove. Fit the front anchorage into its housing.
adaptor. Make sure you hear the click of the pin as it goes in and that the front opening lever is correctly positioned
TOP CASE, insert the key in the vertical position. Operate the locking mechanism as shown in
lock the TOP CASE so that it can neither be opened nor detached from the adaptor. The key can be removed in either the locked o r unlocked
position. 3- To remove the TOP CASE, insert the key in the vertical position, hold the case by the handle, operate the lower part of the ope ning
mechanism and lift up gently until the anchorage comes out of the case. Then pull to remove the upper tongue from the adaptor groove (Fig. H).
Fig. F
SH40-45-46
Fig. G
SH40-45-46
Fig. H
1- Put the key in and leave in the vertical position. Slot the rear
WARNING. It is important to ensure that the case is properly xed to the
(Fig. F). 2- To open the
Fig. G. Turning the key in a clockwise direction will
1.
SH40 CARGO
1
PARTS
P
. s o
R
. f e
a C
. t n
1
0 3
0 5
8 5
4
2
0 3
1 4
2 3
4
CARGO
The maximum load of the case is of:
SH40 - SH40 CARGO: 4 kg
SH42 - SH45 - SH46: 6 kg
2
3
P
. s o
R
. f e
a C
. t n
3
0 2
5 0
4 2
4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Shad SH40
Summary of Contents for Shad SH40
- Page 1 Then pull to remove the upper tongue from the adaptor groove (Fig. H). Fig. F SH40-45-46 Fig. G The maximum load of the case is of: SH40 - SH40 CARGO: 4 kg SH42 - SH45 - SH46: 6 kg SH40 CARGO SH40-45-46 Fig. H PARTS .
- Page 2 (2), the washers (5) and the nuts (6). Fig. B on the SHAD anchoring: Situate the bottom rack of the TOP CASE (1) in the assembly position, remove the fastening clips (2), fasten with screws (7),the rectangular washers (4), the washers (5) and the nuts (6).
- Page 3 Width: 56 / Height: 31 / Depth: 41 Optional brake light D1B40PA plate Optional backrest as an accessory included as an accessory Waterproof Sealing System SHAD puts everything within reach. Find out more about luggage systems & saddlebags we have.
Need help?
Do you have a question about the SH40 and is the answer not in the manual?
Questions and answers
How to detach box from adapter
To detach the Shad SH40 box from the adapter:
1. Insert the key and place it in the vertical position.
2. Hold the case by the handle.
3. Operate the lower part of the opening mechanism.
4. Lift slightly to release the top case from the adapter's anchorage.
5. Pull outward to remove the rear tongue from the adapter groove.
This answer is automatically generated