Shad SH40 Manual

ASSEMBLY INSTRUCCIONS
Once the adaptor has been assembled you are then ready to t the TOP CASE.
tongue into the adaptor groove. Fit the front anchorage into its housing.
adaptor. Make sure you hear the click of the pin as it goes in and that the front opening lever is correctly positioned (Fig. F). 2- To open the
TOP CASE, insert the key in the vertical position. Operate the locking mechanism as shown in
lock the TOP CASE so that it can neither be opened nor detached from the adaptor. The key can be removed in either the locked o r unlocked
position. 3- To remove the TOP CASE, insert the key in the vertical position, hold the case by the handle, operate the lower part of the opening
mechanism and lift up gently until the anchorage comes out of the case. Then pull to remove the upper tongue from the adaptor groove (Fig. H).
Fig. F
SH40-45-46
Fig. G
SH40-45-46
Fig. H
1- Put the key in and leave in the vertical position. Slot the rear
WARNING. It is important to ensure that the case is properly xed to the
Fig. G. Turning the key in a clockwise direction will
1.
SH40 CARGO
1

PARTS

P . s o R . f e a C . t n
1 0 3 0 5 8 5 4
2 0 3 1 4 2 3 4
CARGO
The maximum load of the case is of:
SH40 - SH40 CARGO: 4 kg
SH42 - SH45 - SH46: 6 kg
2
3
Α:
P . s o R . f e a C . t n
3 0 2 5 0 4 2 4