Extreme Canopy EMX Alpha Series Inflatable Instructions

WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
EMX Alpha / Beta / Delta / Gamma / Omega Ranges
Recommended procedure below. For safety reasons it is recommended that 2 persons set up any Inflatable Tent.
ONE
Remove Inflatable Tent from
Protective Cover.
FOUR
Inflatable Tent Accessories*
Layout your Walls and Awnings and
confirm positioning.
SEVEN
Connect the pump to selected Inflation
Valve and begin inflation.
TEN
Fix Stakes and Guide Ropes or attach
Sandbags.
INFLATABLE INSTRUCTIONS

SETUP - INFLATION

Ensure area is free from any sharp objects & overhead objects.
TWO
Roll out the Inflatable Tent.
FIVE
Attach the accessories using zips.
EIGHT
During the inflation process raise legs
into the center until all legs are upright.

IMPORTANT NOTES:

Check the wind and weather
conditions before commencing
construction.
Ensure you have the correct ground
fixings for your application.
When the tent is in use, do not leave
your tent unattended.
We Design | We Manufacture
www.extremecanopy.com admin@extremecanopy.com (888) 201 1968
THREE
Lay the Inflatable Tent out flat.
SIX
Each leg on the Inflatable Tent has a valve.
Select valve to attach pump, screw inflatation
value closed and leave cap off.
On all other valves screw tight and fix cap.
NINE
Ensure all legs are lined up and canopy
is centered. Check frame is firm.
Over pressure relief valve system
DO NOT TOUCH.
| We Sell | We Deliver America Wide