Product Operation; Battery Charging - Hkoenig SWRC90 Operation Manual

6. "
Press this button to start edge cleaning in "Stand by" mode.
7. " "Press button for taking out the dust bin
Press this button to open the top cover and take out the dust bin.

Product Operation

1. Battery charging

A. Charging station placement
Place charging station against the wall and
remove obstacles from within 1 meter at both
sides and about 2 meters in front of the station,
As shown in the right figure.
B. If the robot has been shut down, power on the robot by pressing the power switch at the right
side of the robot for more than 3 seconds.
C. Charge the robot in either way as shown below:
a. Insert the adapter into the robot and the plug at the other end to the power socket as
shown in Fig.a.
b. Press "
to the charging station for recharging as shown in Fig.b.
Note:
a. When robot is being charged, LED panel will gradually show "1111" from left to right.
b. Once charging is complete, LED panel will show "FULL".
c. In the standby status, the robot will broadcast voice "Please charge" and LED panel will show "
when battery power is low.
" Edge Cleaning Mode
" on robot or "HOME" on remote control to operate the robot to go back
9
"