Hotpoint WLW2500B Use And Care Manual page 8

How tome
the B1achmnser
. Use this dispenser with liquid
bleach only. If you prefer to use
powdered bleach, pour it into the
Do not put powdered bleach into the
bleach dispenser.
Measure bleach carefully. Here
are some recommended amounts:
FULL WATER LEVEL—1%
(310 ml) liquid
LOW WATER LEVEL–2/3
(170 ml) liquid
Pour measured amount of liquid
bleach direcdy into bleach dispenser.
Do not overftil or allow dispenser
Avoid splashing.
to overflow.
Undiluted bleach can cause fabric
damage.
Never pour undiluted liquid
bleach directly onto clothes or into
the wash basket.
How tome
the Soak setting
OFF
HEAVY SOIL
/
. ~~sOAK?' setting temperature
will automatically be cold.
desired, set the WASH/RINSE
TEMPERATURE switch to
and turn the Cycle Selector knob to
"Heavy Soil:' Start the washer.
After washer fills and begins to
agitate, push in the Cycle Selector
knob and turn to "SOAK:' Pull
out the Cycle Selector knob to
complete the cycle.
allow the
For an extended soak
washer to fill and agitate for a few
minutes to dissolve the soaking
agent. Then push in the Cycle
Selector knob to stop the washer
(keep lid closed) and allow to soak
for as long as desired. After
desired soak period, pull out the
Cycle Selector knob to complete
the cycle.
8
If your clothes and household items
don't look clean and fresh after
washing, you will probably re-wash
them. . and that means you'll waste
energy. Remember to sort your
clothes carefully, and load them
properly, select correct cycles, use
enough detergent and
choose a
water temperature warm enough to
release and get rid of soil.
Use Hot Wash—up to 150°F.—on
when washing
a regular basis only
heavily soiled articles-such as
work and play clothes.
. Under norrnd soil conditions, wash
in water above 80°F. (27°C.). This
temperatures approximately 90° to
notice that soil has accumulated after
Wash occasionally, if safe for fabrics.
. Try to wash less often. Save
articles of the same type of fabric
until you have a full load.
. If you must wash smaller loads,
adjust the amount of water. Small
loads should have lower water levels.
Your local utility can tell you which
are the off-peak hours.
more water and help lessen drying
time. The dryer will remove any