Table of Contents
Advertisement
The Problem Solver
PROBLEM
WATER
TEMPERATURE
IS INCORRE~
WATER WON'T
WATER LEAKS
WASHER IS NOISY
WASHER PAUSES
IN ~CLE
If you need more help.. call, toll free:
The GE Answer Cente@
consumer information semice
POSSIBLE CAUSE AND REMEDY
sure temperature selector switches are correctly set.
Make
Make sure hot and cold faucets are turned on and
hot, cold to cold.
hot to
Water valve screens may be stopped up. Remove inlet
hoses from water valve. Clean the screens and reinstall hoses.
Check household water heater to make sure it is delivering water at 140° to UO°F.
Make sure drain hose is not kinked.
Top of drain outlet should be less than 8 ft. above floor.
Make sure hose connections are tight at faucets.
Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your kstilation Instructions.
A sharp distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission "locks in~' This sound is normal.
and may cause it to move from its original position. In extreme cases, (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary) the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, open the lid and redistribute the load evenly about the wash basket. Close
the lid and restart.
. Washer normally pauses between washing steps. . . such as between wash and spin or
between spin and rinse.
22
o % $ ?
Advertisement
Table of Contents
