Emerald Physics EP 200.2SE Owner's Manual page 7

Connection Warning
Disconnect the AC cord before making or changing any input or hooking up any
speaker wire to the amplifier. Make sure there is no strain or tension on any wires that
could cause them to pull loose.
Stereo system operation: Connect shielded audio cables from your source
components (i.e. CD Player, Streamer etc.) output jacks to the input section of your
200.2SE. The Integrated Amp has 2 RCA & 1 XLR inputs. Use any of the 3 inputs and
make sure the input switch is set to your desired input by toggling the remote control or
using the Input Knob on the front panel. The remote is simple yet effective – see picture
below.
Special Pre/ Post Volume Control
The 200.2SE is equipped with an Alps Motorized Volume Control. That said, this control
may be used in several different configurations actuated by a switch marked Pre/Post
located Center/Top of the rear panel.
7