Philips LPC3180 Application Note page 10

Getting started linux with
Table of Contents

Advertisement

Philips Semiconductors
lpc3180_kbd: Requesting IO Region: 40050000 - 0080
lpc3180_kbd: Memory mapped to c2006000
lpc3180_kbd: creating proc entry
keyboard-lpc3180: driver running on platform=lpc3180
lpc3180_kbd: Setting up registers
lpc3180_kbd: initialising driver
lpc3180_kbd: registering device
lpc3180_kbd: lpc3180 keyboard open called
sysfs entry reg
lpc3180_kbd: LPC3180 keyboard driver initialized
LPC3180 Event Router driver
Debug Level 1
Requesting IO Region: 4000C000 - 0018
Memory mapped to c2008000
Requesting IO Region: 40010000 - 0018
Memory mapped to c200a000
Requesting IO Region: 40008000 - 0018
MIC Memory mapped to c200c000
gpio_leds : driver compiled Dec 14 2006 at 15:46:09
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.0:USB HID core driver
About to register ohci_hcd_lpc3180_driver
About to register ip3506_ohci
ohci ohci1: at 0xf1020000, irq 59
init_otg_dualrole_fsm
usbcore: registered new driver catc
drivers/usb/net/catc.c: v2.8 CATC EL1210A NetMate USB Ethernet driver
usbcore: registered new driver kaweth
drivers/usb/net/rtl8150.c: rtl8150 based usb-ethernet driver v0.6.2 (2004/08
/27)
usbcore: registered new driver rtl8150
usbcore: registered new driver usbnet
drivers/usb/net/pegasus.c: v0.5.12 (2003/06/06):Pegasus/Pegasus II USB Ether
net driver
usbcore: registered new driver pegasus
spi-lpc3180: SPI Test Dec 14 2006 CS driver running on platform=premo
Found clock frequency for spi-1 is 104000000
initialising CS table
Found clock frequency for spi-2 is 104000000
initialising CS table
isp1301_generic 1-002d: chiprev 2.10, driver 26 May 2006
pshs_uart probe: Using 7 dma req for TX and 8 dma req for RX
ttyPSHS0 at MMIO 0x40018000 (irq = 25) is a PSHS
pshs_uart probe: Using 9 dma req for TX and 10 dma req for RX
ttyPSHS1 at MMIO 0x4001c000 (irq = 25) is a PSHS
pshs_uart probe: Using 5 dma req for TX and 6 dma req for RX
ttyPSHS2 at MMIO 0x40014000 (irq = 25) is a PSHS
usbcore: registered new driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial Driver core v2.0
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI SIO
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI 8U23
2AM Compatible
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI FT23
2BM Compatible
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI FT22
32C Compatible
drivers/usb/serial/usb-serial.c: USB Serial support registered for USB-UIRT
Infrared Tranceiver
drivers/usb/serial/usb-serial.c: USB Serial support registered for Home-Elec
tronics TIRA-1 IR Transceiver
<12NC>
Application note
Rev.03 — 21 Dec 2006
AN10476
Getting started Linux with LPC3180
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
10 of 28

Advertisement

Table of Contents
loading

Table of Contents