Tacho Connection - Sauer Danfoss OMS Series 3 Repair Instructions

Tacho Connection

OMS/OMSW Orbital Motor
Repair Instruction
Dismantling
Item Part to remove
51 Screw (4 off )
44 Tacho connection
48 O-ring
46 Spacer ring
56 Retaining ring
55 Shaft seal
53 Retaining ring (2 off )
54 Bearing
After dismantling, clean all parts in low aromatic kerosene.
Examine the parts and exchange them if necessary.
Immidiately before assembly, lubricate each part with hydraulic oil and grease rubber
parts with vaseline.
L1012850 • Rev AB • Sep 2010
Comments
Remove from tacho valve housing
Loosen tacho shaft package (by tapping lightly at the
end of the shaft) and extract the package
tacho housing.
from
11