Download Bitmap To Srp-350 From A Pc - Samsung SRP-350 Integrator's Manual

Download Bitmap to SRP-350 from a PC

The Windows application program BmpLogo.exe is used to send a bitmap to the flash ROM of
the SRP-350 POS printer.
The application is available from the dealer area of the CRS web site, www.crs-usa.com.
This program will work with Windows 95\98, and Windows 2000 (only with file system
FAT32). In Parallel mode, the program will only work in bi-directional\EPP mode. The
program will not work in ECP mode. This mode can be changed in CMOS.
1. Start the BmpLogo application. (Click Start, and then Run. Type the path and program
name into the Open field; click OK. Alternatively you can launch the application by
double-clicking on the file in Windows Explorer.) The application displays with the
Setup tab in the forefront.
2. Select the port to which the SRP350 is connected, and then fill the remaining fields to
match the settings on the SRP350. Use the table below as a guide:
8 • Logo Setup
Option BmpLogo Program Setting
Baud rate 9600
Bit length 8
Parity NONE
Stop Bit 1
Handshake DTR/DSR
SRP350 Dip Switch
Setting
SW1 #7=ON; #8=OFF
SW1 #4=OFF
SW1 #5=OFF
SW1 #6=OFF
SW1 #3=OFF
Samsung SRP-350 Setup & Service Information