Table of Contents
Advertisement
2. Pro-Picture menu
Some picture adjustments are available only when certain input sources are in use.
Unavailable adjustments are not shown on the screen.
FUNCTION
(default
DESCRIPTION
setting / value)
Automatically resizes the input signal pixel resolution to the native resolution
of the projector.
On: The pixel resolution of the input signal is converted to the native
resolution of the projector (1024 x 768). For input signals with lower
Auto Resize
resolutions, gaps in the pixels are automatically interpolated into the image
before being projected. This may distort the image clarity.
(on)
Off: The image is projected as its original resolution, with no pixel conversion.
For input signals with lower resolutions, the projected image will display
smaller than if resized to full screen. You could adjust the zoom setting or move
the projector towards the screen to increase the image size if necessary. You
may also need to refocus the projector after making these adjustments.
There are two aspect ratio settings.
1. 4:3 (for a standard screen)
Aspect Ratio
(4:3)
Adjusts the horizontal position
of the projected image.
H Position
(0)
Adjusts the vertical position of
the projected image.
V Position
(0)
This function allows you to adjust the clock phase
Phase
to reduce image distortion.
(depends on
the selected
input
source)
Adjusts the horizontal width of the image.
H Size (0)
Adjusts the image to make it look sharper or softer.
Sharpness
(15)
16:9 aspect ratio is only sourced through the Component Video input
when being fed an appropriate 16:9 aspect signal. See
Component Video source device" on page 22
preferred projected image size" on page 15
2. 16:9 (for a wide screen)
and
"Obtaining a
for details.
-30
-30
"Connecting a
+30
+30
Operation
35
Advertisement
Table of Contents
