Table of Contents
Advertisement
Controls and functions
External control panel
I
1.
Power (Refer to
I
information.)
Turns the projector on or off.
2.
Blank (Refer to
Used to hide the screen image. You can press any key on the control panel to bring the
image back.
3.
Mode (Refer to
Depending upon which input signal is selected, there are several picture setup options
available.
When a wireless module is installed and the Wireless Connection menu is displayed,
press this button to change among LAN, IEEE 802.11 a, and IEEE 802.11 b/g. (The
wireless module is available through BenQ retailers.)
4.
Source (Refer to
Sequentially selects the input signal RGB, Component Video, S-Video, or Video.
5.
Auto (Refer to
Automatically determines the best picture timings for the displayed image.
When a wireless module is installed, the Wireless Connection menu is displayed and
the IEEE 802.11 a is selected, press this button to search for a reliable channel. (The
wireless module is available through BenQ retailers.)
6.
Lamp indicator light (Refer to
Indicates the status of the lamp. Lights up or flashes when the lamp has developed a
problem.
7.
Temperature warning light (Refer to
Lights up red if the projector's temperature becomes too high.
13
14
8
1
9
2
"Start up" on page 25
"Hiding the image" on page 29
"Application Mode" on page 33
"Switching input signal" on page 29
"Auto-adjusting the image" on page 27
"Indicators" on page 47
"Indicators" on page 47
7
12
6
5
10
3
11
4
and
"Shutdown" on page 30
for more information.)
for more information.)
for more information.)
for more information.)
for more information.)
for more information.)
for more
Introduction
9
Advertisement
Table of Contents
