Table of Contents
Advertisement
Removing the Spare Battery
Press and hold
to power off your FWT and then disconnect the FWT from the
power socket. Then remove the battery house cover. Disconnect the battery cord and take
out the spare battery.
Installing the Antenna
Installing the Antenna
Power off your FWT and disconnect the FWT from the power socket. Then connect the
antenna to the antenna jack on the Main unit. Make sure that the antenna is stably
connected to the antenna jack.
Checking the Signal Strength
1. After installing the antenna, press and hold
the signal strength icon appears or you can hear the dialing tone when you lift the
handset.
2. If the signal strength icon does not appear after five minutes or you hear the failure
tone when you lift the handset, it indicates that the FWT is not receiving signals. In this
case, you need to adjust the direction of the antenna until you can hear the dialing tone
on lifting the handset.
3. If there is no signals even after you adjust the antenna in 360 degrees angle, it indicates
that the signal is weak in the particular site. Either change the site or consult your
service provider.
Connecting the FWP to a PC
The FWP can be connected to a PC to provide data services. Data services include Internet
surfing and faxing. To use data services, you need to purchase the data service suite and
connect the FWP to a PC as show in the following figure
12
to power on your FWT. Wait until
Advertisement
Table of Contents
