Turning The Headset On/Off; Playing Music; Charging The Headset; Pairing The Headset - Mio BTH200 User Manual

1. Charging the headset

The headset comes with a built-in rechargeable battery, prior to using it, it is recommended to charge the battery fully for the first time. When the headset is low
power, the headset emits "Dongdong" tones about every 20 seconds and the red LED flashes. Please recharge the battery of the headset.
How to charge the headset:
Plug USB charging cable into the USB port of computer and connect the micro connector to the headset
It will take about 3 hours to finish charging

Red light on: Charging

Red light off: Finished charging

2. Turning the headset on/off

Functions
Turning On
Turning Off
Note: In order to save power, the headset will turn off automatically if no devices are connected after 5 minutes.

3. Pairing the headset

Functions
Entering pairing mode
3-1. Pairing the headset—Notes
Prior to using the headset for the first time, you have to pair it with a Bluetooth-enabled device. The pairing procedures may differ pending on the model of the
device you're trying to pair. Please refer to your device/phone user manual for further information.
The general pairing procedures are as follows:

Keep your headset and phone within 1 meter when pairing;

Start the pairing mode operation on your headset (see #3 pairing headset)

Activate your device Bluetooth function and set your device to search for Bluetooth devices within range and select "BTH200" from the list of devices shown;

Enter PIN/ Password No: "0000"( Note: If the mobile phone supports Bluetooth V2.1, password is not required.)

If prompted by your device to connect, select "Yes"

After successfully connecting, blue LED light on the headset flashes 2/3 times every 4 seconds
Notes:

If pairing failed, please turn off the headset first and then re-pair according to steps 1-6 mentioned above.

After initial pairing, the headset and the device will remember each other, they will no longer need to re-pair next time. The headset can store up to 8 paired devices. When the
number of paired devices exceeds 8, the first one will be replaced.

4. Playing Music

When the headset connects to a mobile phone or Bluetooth transmitter which supports A2DP, you can enjoy music wirelessly through the headset.
2
Press and hold MFB button for 4 seconds until blue LED flashes
Press and hold MFB button for 4 seconds until red LED flashes
Ensure the headset is off, and then press and hold the MFB button for 7 to
8 seconds until red and blue LED flash alternately
Functions Status of the headset
Volume up Playing music
Volume down Playing music
Rewind Playing music
Fast forward Playing music
Pause Playing music
Play Pausing music
Operation
Operation
LED indicator
Press + button
Press - button
Press ◄ button once
Press ► button once
Press MFB once
Press MFB once
www.everik.com
LED indicator
Blue LED on one second
Red LED on one second
LED indicator
Red and blue LED flash alternately
BTH200.KM.072013.IM