Table of Contents
Advertisement
Cleaning Your Mini-Compact
System
GB
To obtain the best possible results from your mini-compact
system, you must clean the following elements regularly:
The outer casing
The compact disc player
The cassette players (heads, rollers and drive capstans)
Always unplug the system from the wall outlet:
Before cleaning it
If you are not going to be using it for a long time
Outer Casing
Clean the outer casing regularly using a soft cloth and a light detergent. Do
not use abrasive powders, liquids or aerosol cleaners. Never let any liquids
get into the system.
Compact Disc Player
1
Before playing a compact disc, clean it with a special CD cleaning
agent. Do not use the same cleaning agents as for vinyl LP records.
Carefully wipe the disc from the centre outward.
2
Regularly clean the player with a special cleaning disc (available from
your local dealer).
Tape Decks
1
Press STOP/EJECT(
2
Use a cotton bud and a special cassette cleaning agent to clean the:
Head (1)
Rollers (2)
Drive capstans (3)
If you will not be using the remote control for a long time,
remove the batteries to prevent corrosion.
Although your system is very hard-wearing, it should not be
used in an excessively dusty environment or subjected to
shocks or extreme heat (close to heating appliances or in
direct sunlight, etc.).
If the unit emits an unpleasant odor when in use, unplug it
from the main supply and contact the after-sales service.
Precautions When Using Compact
Discs
Handle your compact discs with care. Always hold them by
the edges to avoid leaving fingerprints on the shiny surface.
When you have finished playing a compact disc, always put it
back in its case.
Do not fix paper or adhesive tape to the discs and do not write
on the label.
Clean them with a special-purpose cloth.
Store your compact discs in a clean place, out of direct sun-
light, where they will not be exposed to high temperatures.
Always use compact discs marked
24
) to open the cassette deck.
3
1
2
COMPACT
.
DIGITAL AUDIO
Precautions When Using Audio
Cassettes
Check that the tape in the cassette is sufficiently taught.
To prevent erasing a cassette that you wish to keep, remove the safety
tab on the upper edge of the cassette. To record a cassette, where the
tab has been broken, simply cover the opening with adhesive tape.
When you have finished playing a cassette, always put it back in its case.
Store your cassettes in a clean place, out of direct sunlight, where
they will not be exposed to high temperatures.
Avoid using 120-minute cassettes as they place unnecessary strain
on the tape mechanism.
Before Contacting the After-Sales
Service
It always takes a little time to become familiar with a new appliance. If you
have any of the problems listed below, try the solutions given. They may
save you the time and inconvenience of an unnecessary service call.
Problem
The system does not work
G
E
There is no sound
N
E
R
A
L
The Timer does not work
The compact disc player does not
start playing
C
D
C
A
The tape does not start playing
S
S
E
T
T
E
The volume falls off
S
The cassette is not erased correctly
There is excessive wow and flutter
Reception is poor or no radio sta-
tions are received at all
R
A
D
I
O
If the above guidelines do not allow you to solve the problem, take a note of:
The model and serial numbers, normally printed on the rear of the system
Your warranty details
A clear description of the problem
Then contact your local dealer or SAMSUNG after-sales service.
Checks/Explanation
• The main lead is not correctly plugged into a
wall socket or the wall socket is not switched on.
• The remote control batteries need replacing or
the polarity has not been respected.
• The POWER button has not been pressed.
• The volume has been completely turned down.
• The correct function (TUNER, CD, TAPE,
AUX) has not been selected.
• You have connected a set of earphones.
• The loudspeaker wires have been disconnected.
• The MUTE button has been pressed.
• The timer has been stopped by pressing
TIMER ON/OFF.
• The CD function has not been selected.
• The disc has been inserted face down or is
either dirty or scratched.
• The laser sensor is dirty or dusty.
• The system has not been installed on a flat,
horizontal surface.
• Condensation has formed in the player; leave
the system in a warm, airy room for at least
one hour.
• The TAPE function has not been selected.
• The cassette has not been inserted correctly.
• The cassette player has not been closed.
• The tape is either slack or broken.
• The audio heads are dirty.
• The rollers or drive capstans are dirty.
• The tape is worn.
• The TUNER function has not been selected.
• The radio frequency has not been correctly
selected.
• The aerial has been disconnected or is not fac-
ing the right way. Turn it until you find the best
orientation.
• You are in a building that blocks radio waves;
you must use an outside aerial.
Hide quick links:
Advertisement
Table of Contents
