AEG SANTO SU96040-5I Operating Instructions Manual page 58

What to do if...
Appliance cools too much.
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the door
seal.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Water on the floor or on
storage shelves.
58
Symptom Possible Cause
Temperature is set too
cold.
Temperature is not proper-
ly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Light bulb is defective.
Door seal is not air tight
(possibly after reversing
the door).
Appliance is not level.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
This normal, no error has
occurred.
Water drain hole is
blocked.
Remedy
Turn the temperature
regulator to a warmer set-
ting temporarily.
Please look in the "Starting
Up and Temperature regu-
lation" section.
Open the door only as long
as necessary.
Turn the temperature reg-
ulation to a colder setting
temporarily.
Please look in the
"Installation location" section.
Please look in the "Changing
the Light Bulb" sections.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
Readjust the feet.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.