Table of Contents
Advertisement
Available languages
Available languages
822_949_188 EWA1700.book Seite 9 Mittwoch, 2. August 2006 5:22 17
The automatic switch off
The kettle will switch itself off auto-
matically and the pilot light will go out
when the water has boiled.
If you want to stop the heating process
before the kettle automatically
switches off, simply press the ON/OFF
switch (E) up or lift up the jug from the
base. If you want to reheat water
which has already been heated, press
the ON/OFF switch (E) down again.
When the water is boiling the kettle
switches itself off automatically.
Safety system
This appliance is equipped with a boil-
dry safety cut-out. This feature pro-
tects the appliance from overheating
when started without water or from
boiling until it is empty if used with
the lid open. If the appliance is acci-
dently switched on without water, it is
automatically protected against over-
heating. The heating process is auto-
matically interrupted. Before using the
kettle again let it cool down for 5-
10 minutes.
Cleaning and care
1
Always disconnect the kettle from the
mains supply before cleaning.
Never clean the kettle and base unit
1
under running water or immerse it in
washing-up water.
0 Occasionally rinse out the kettle with
clean water.
0 Clean the outside of the appliance only
using a damp cloth. Do not use any
caustic or abrasive cleansing agents.
Descaling
The appliance should be descaled regu-
larly depending on the level of the
water hardness. Use a standard des-
caler following the directions; prefera-
bly choose an environmentally friendly
product.
0 First fill in water, then a standard des-
caling preparation which is not too
strong.
1
Do not boil the solution as it could
foam over.
0 After descaling, rinse the kettle out
thoroughly with clean water. Never
pour descaling agents into an enamel
sink and do not reuse them.
Technical data
Mains voltage:
Power drain:
;
This appliance complies with the fol-
lowing EC directives:
• 73/23/EEC of 19/2/1973 "Low voltage
directive", including the modification
directive 93/68/EEC.
• 89/336/EEC of 3/5/1989 "EMC direc-
tive", including the modification direc-
tive 92/31/EEC.
g
220–240 V/50 Hz
2400 W
9
Advertisement
Table of Contents
