Sony Ericsson P1C User Manual page 37

Table of Contents

Advertisement

Draft for Sony Ericsson Internal Use Only P1C
Guidelines for Safe and Efficient Use
Please read this information before
using your mobile phone.
Recommendations
Always treat your product with care
and keep it in a clean and dust-free
place.
Do not expose your product to liquid
or moisture or humidity.
Do not expose your product to
extreme high or low temperatures.
Do not expose your product to open
flames or lit tobacco products.
Do not drop, throw or try to bend your
product.
Do not close your product with an
object inserted between keypad and
display; this may damage your
product.
Do not paint your product.
Do not use your product near medical equipment
without requesting permission.
Do not use your product when in, or around
aircraft, or areas posted "turn off two-way radio".
Do not use your product in an area where a
potentially explosive atmosphere exists.
Do not place your product or install wireless
equipment in the area above your car's air bag.
Do not attempt to disassemble your
product. Only Sony Ericsson
authorised personnel should perform
service.
Antenna
Only use an antenna that has been specifically
designed by Sony Ericsson for your mobile phone.
Use of unauthorised or modified antennas could
damage your mobile phone and may violate
regulations, causing loss of performance and SAR
levels above the recommended limits (see below).
38
Important information
Efficient use
Hold your mobile phone as you would any other
phone. Do not cover the top of the phone when in
use, as this affects call quality and may cause the
phone to operate at a higher power level than
needed, thus shortening talk and standby times.
Radio frequency (RF) exposure and
SAR
Your mobile phone is a low-power radio transmitter
and receiver. When it is turned on, it emits low
levels of radio frequency energy (also known as
radio waves or radio frequency fields).
Governments around the world have adopted
comprehensive international safety guidelines,
developed by scientific organizations, e.g. ICNIRP
(International Commission on Non-Ionizing
Radiation Protection) and IEEE (The Institute of
Electrical and Electronics Engineers Inc.), through
periodic and thorough evaluation of scientific
studies. These guidelines establish permitted levels
of radio wave exposure for the general population.
The levels include a safety margin designed to
assure the safety of all persons, regardless of age
and health, and to account for any variations in
measurements.
Specific Absorption Rate (SAR) is the unit of
measurement for the amount of radio frequency
energy absorbed by the body when using a mobile
phone. The SAR value is determined at the highest
certified power level in laboratory conditions, but
the actual SAR level of the mobile phone while
operating can be well below this value. This is
because the mobile phone is designed to use the
minimum power required to reach the network.
Variations in SAR below the radio frequency
exposure guidelines do not mean that there are
variations in safety. While there may be differences
in SAR levels among mobile phones, all Sony

Advertisement

Table of Contents
loading

Table of Contents