Switching On; Switching Off The Fridge; Switching Off The Appliance; High Temperature Alarm - AEG SANTO C 8 18 42-6i User Manual

6
Control panel

Switching on

1. Insert the plug into the mains socket.
2. Press ON/OFF switch .
3. The Pilot Light will light up.
4. The alarm indicator light flashes since the temperature is reached.
The acoustic alarm sounds.
5. Press the alarm reset button to reset the alarm.

Switching off the fridge

1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the fridge is turned off. The temperature indicator switches off. The Pilot light
switches off.

Switching off the appliance

1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the appliance is turned off. The temperature indicator switches off. The Pilot
light switches off.

High temperature alarm

In the event of an abnormal temperature rise inside the freezer (e.g. power cut) alarm
indicator light will start to flash and a buzzer will sound.
Push the alarm reset button to stop the buzzer sound, while the alarm indicator light will
continue to flash.
The buzzer will stop automatically when the temperature has returned to normal while the
alarm indicator light will continue to flash.
Press the alarm reset button. The alarm indicator light goes out and at the same time the
freezer temperature indicator show for about 5 seconds the warmest temperature reached
in the freezer compartment.

Temperature setting buttons

The temperature is adjusted using the temperature setting buttons. These buttons are con-
nected to the temperature indicator.
• The temperature indicator is switched over from the indicator of the ACTUAL tempera-
ture (Temperature indicator is illuminated) to the indicator of the DESIRED temperature
(Temperature indicator flashes) by pressing one of the Temperature setting buttons.
• Each time one of the two buttons is pressed again the DESIRED temperature is adjusted
by 1°C. The DESIRED temperature must be reached within 24 hours.
If neither button is pressed, the temperature indicator automatically switches back after a
short period (approx. 5 sec.) to the indicator of the ACTUAL temperature.
DESIRED temperature means:
The temperature that has been selected for inside the corresponding compartment. The
DESIRED temperature is indicated by flashing numbers.
ACTUAL temperature means:
The temperature indicator shows the current temperature inside the corresponding com-
partment. The ACTUAL temperature is indicated with illuminated numbers.