Using Your Headset - Creative CB2455 Getting Started

Wireless Bluetooth headset_cutdown.fm Page 4 Wednesday, December 29, 2004 6:11 PM

Using Your Headset

Usage Action
Turning on Press and hold the Multi-function button for three seconds. The LED turns
headset blue.
Turning off
Press and hold the Multi-function button until the LED turns red.
headset
Make sure that your headset is turned on (it may be in standby mode when
Making a call
inactive), dial the number, and then proceed with your call.
If there is an incoming call, your earpiece and mobile phone rings, and your
Answering a call
headset beeps. Press the Multi-function button.
Press the Multi-function button to end a call. You can also end a call using
Ending a call
your mobile phone.
Press the Multi-function button and when you hear a beep, say the voice
Voice Dial*
tag.
Last Number
Press the Multi-function button twice within one second.
Redial*
Press the Volume Increase or Volume Decrease button to gradually
Adjusting volume
increase or decrease the volume.
Rejecting a call Press and hold the Multi-function button for three seconds.
Putting a call on Press and hold the Volume Increase and Volume Decrease buttons
hold simultaneously, for one second.
Switching between Press the Volume Increase and Volume Decrease buttons
calls simultaneously.
Press and hold one of the Volume buttons until the LED alternately blinks
red and blue.
Mute
To unmute the microphone, press and hold one of the Volume buttons until
the LED blinks blue.
Make sure that your headset is turned off. Press and hold one of the Volume
buttons for 20 seconds. The LED alternately blinks red and blue. Press and
Clearing all
hold one of the Volume buttons again until you hear two beeps. Charge
headset pairings
your headset for a few seconds to reset your headset. All current pairings
are cleared.
*Some features are available only for certain mobile phones. Refer to your mobile phone's documentation.
4