Sleep (Remote Control Only) - Philips BTM288 User Requirement Specification

4. SLEEP: (REMOTE CONTROL ONLY)
Electronic key (SLEEP) on Remote control only
4.1. Press SLEEP key on the remote control repeatedly to select the desired time period (in minutes).
Display shows in sequence: SLEEP 90
The "SLEEP zZZ" flag in the display will be turned on.
4.2. To deactivate the sleep timer, press SLEEP key again until the icon "SLEEP zZZ" turn off or press
STANDBY key.
4.3. If Sleep is already activated, press the SLEEP key once will shows the remaining sleep time, press
the key again will change the sleep time to the next higher increment.
Remark:
If sleep is activated, the unit will go to Standby (even there might be a damage to the capstan
mechanism). If alarm arrives at the same time as sleep ends, the unit will go to Standby mode.
If sleep ends earlier then the alarm, the alarm will turn on the set; if the alarm is earlier then
the sleep ends, sleep will put the unit to Standby.
SLEEP cannot be activated, when no time has been preset.
Page 6 of 56
75 60 45 30 15 OFF. Default is 0 min.
Ver 1.0 Update : 2 Jun 2007