Instructions For The Installer; Installing The Appliance; Transportation, Unpacking; Cleaning - AEG S 70170 TK3 Instruction Book

GB

Installing the appliance

Transportation, unpacking

It is recommended to deliver the appliance in
original packaging, in vertical position considering
the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.

Cleaning

Remove every adhesive tape, which ensure the parts not to
move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.

Placement

The ambient temperature has an effect on the energy
consumption and proper operation of the appliance. When
placing, take into consideration that it is practical to
operate the appliance between ambient temperature
limits according to the climate class that is given in the
chart below and can be found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
48

Instructions for the Installer

Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
breakdown in the automatic defrosting increasing
temperature in the cooling compartment or increasing
energy consumption.
When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet (1) at the
bottom in front. 1-1 piece of distance washer (2) are
accessories of the adjustable feet. If levelling the appliance
requires, these washers can be removed.
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the
appliance has to be stood near a cooker take these
minimum distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5-1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.